Decals as per DML’s instructions. I used the 4 in the red circle and it’s a good think the Dragon boys and gals had included a spare. Decals were tamed using my favorite Mr. Mark Softer from Gunze, then covered with Vallejo matt varnish.
Since the tank has been painted with about 7 variations of green I used a bit less pigment powders (Agama Sand, Dust and a bit of white) than usual to weather it. A bit of black behind the exhausts, around machine guns and gun muzzle and again a coat of Vallejo flat.
Another Armorama review build. This was one of those rare occasions when I decided to strictly follow the instructions.
I started by test-fitting the turret top and bottom. The locating pins in the turret base detail are too thick, so a step step was formed – they were quickly removed.
Turret with its bottom end up – the step is rather evident…
Since two options were presented for the main turret armament (parts C3 and B7) I went with the longer one 🙂 The aft end of the detail required some sanding to fit in the turret mask. Next, the Besa machine gun was glued in the mask. After the assembly was glued to the turret base (C5), I added the top detail (C9) to close the turret.
Well,considering the aging releases by ESCI, Airfix and Hasegawa the Braille scale world has been aching for a modern kit of this important machine for quite some time. Well – here’s DML’s attempt.
The kit contains 70 parts:
68 in grey plastic
2 runs of DS track
Oh I hear your cries about NO PE parts, but rest assured – this is a non-issue with the kit.
There are two main hull components, cast as separate parts – the upper one represents the top deck and the fenders, and lower part is the slide-molded hull tub.
Hull tub bottom – a look from front to backHull tub bottom – aft end
It is interesting to note that there are fuel can racks at the aft end of the fenders, and Dragon has included two pairs of British-style 2 gallon cans to be posed there should the modeler so desire.
