– windows in the doors, attempted imitating seals with acrylic gel and paint;
– weathering, and a lot of it. An experiment with a new technique went so far as to lead to completely strip-down of the paint on the hull/cargo bed assembly.
In the first part of the build I basically completed the lower half of the vehicle and the cargo bed. Back to the crew compartment.
The AT-T’s front lights reside at the very front of the bonnet/hood on metal supports. In the kit these are PE parts, which supposedly butt-join the resin engine compartment, and on top of which the lights are glued. Images of broken-off detail in my mind lead me to soldering a piece of wire (in red) through each support like this (looking from the front):
I started construction with the chassis tub. First thing to do is gluing the back wall. Next I cut the suspension arms out of the casting block and it turned out the holes for their pins are much too small. Off with the pins, arms are drilled through, as is the tub itself – naturally observing the locations of the original holes.
I decided to use thick copper wire passing through the whole tub to make new pins. This would ease me in terms of affixing the pins and make the whole thing stronger.
“An old soldier, but not faded away yet” – that’s the way the fate of this kit can be summed up – at least in my own collection.
It all started up about 5 years ago with the impulsive purchase of the kit. Nice details, simple construction, interesting decal options (both shark-mouthed), and a comprehensive weapon set at a very reasonable price. A few months later it was destined to become the cure for a modeller’s block. Then it was cutting the flaps out, then some scratchubilt details in the cockpit. Guns are replaced with needles of two different diameters, filling and sanding of fuse seam are in order. So far so good (that’s middle of 2007):
